$ 26.06

• 8'' scrub resin set
• Stiff polyester at two trim levels
• Solid polypropylene block
• Resin Set
• May be autoclaved at 273F/134C
• Blue, green, red, white or yellow
• Bagged and bar coded
• Six per case

This tough scrub is comfortable to hold, and is double winged for maximum cleaning action. It has an integral hanging hole. The product is made with a solid polypropylene block, which is shock, distortion and crack resistant, and unlike 'structural foam' polypropylene is not brittle or easily chipped. Its surfaces are smooth and easily cleaned. And it is non absorbent and rot proof. Polyester filaments have a high melt point, low water absorption factor, excellent tensile strength and very good sweeping characteristics. They will last many times longer, and clean far better, than standard polypropylene filaments. This product may be autoclaved at 273F/134C, or cleaned using standard cleaning agents, disinfectants and sanitizers. In a resin set brush, the tufts are secured with stainless steel staples AND epoxy resin. This locks the filaments in, and makes the chance of a strand pulling out extremely remote, as well as effectively inhibiting the accumulation of any soil or moisture in the tuft holes. Resin set brushes are usually recommended for areas of particular hygienic sensitivity. See ST5 for a non-resin set version, and see also ST8 and ST10. If you can't find the scrub you want on this site see also the following at www.hillbrush.com: ST7, ST9.